2-Wheel Drive Class

1. Must have professional looking body with a firewall between driver and engine.

2. Must have a properly secured roll-cage constructed of 1 5/8” round tubing.

3. Must have a properly functioning brake system to adequately stop the vehicle within 200 feet.

4. Must have a master shut off switch located on the rear of vehicle in the center (not on sides).
5. Vent line required on fuel cell. Must extend 6" below fuel cell and be secured. No open vents on top of tank.

6. Two wheel drive only.

7. Any safe chassis permitted

8. Any production Transmission permitted.

9. Trans-brake permitted.

10. Transmission shield or blanket required.

11. Stall converter permitted.

12. Drive shaft loops required. (Where applicable.)

13. Gas or alcohol permitted.

14. Any small or big block less than 500 cubic inches permitted.

    • Sfi approved damper and flywheel recommended.

    • No aluminum blocks.

    • Any size camshaft.

    • Aluminum heads permitted.

    • One four barrel carburetor permitted.

    • No blowers, superchargers, turbos or nitrous.

15. Any tire and wheel combination.

All General Rules Apply.